Home › Code lookup › P043E
Powertrain code · Emissions

P043E Evaporative Emission System Leak Detection Reference Orifice Low Flow

How urgent? Book a check when convenient

What it means

Some fuel vapor systems use a small pump with a tiny calibrated hole to test for leaks. The computer sees less air flowing through that reference hole than it should, which usually means it is blocked.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the vent hose and canister filter for dirt, water or bugs
  2. Run the EVAP leak test with a scan tool and watch pump pressure readings

Signs you may notice

  • Check engine light on
  • No change in how the car drives
  • Other EVAP codes may set at the same time

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed leak detection pump module
  • CommonReference orifice or filter clogged with dirt or debris
  • PossibleBlocked vent hose or canister filter
  • PossibleWiring problem to the pump module

Typical repair once the cause is confirmed

Usually a new leak detection pump module, sometimes with the charcoal canister.

Repair costInsufficient verified pricing for this vehicle and repair
Replace EVAP leak detection pump module. Prepare an itemized shop request.

Where it shows up

  • Often seen on Toyota and Lexus models that use a canister-mounted leak detection pump

Common questions

What does P043E mean?

Some fuel vapor systems use a small pump with a tiny calibrated hole to test for leaks. The computer sees less air flowing through that reference hole than it should, which usually means it is blocked.

Can I drive with code P043E?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P043E?

Common possibilities to test include: failed leak detection pump module; reference orifice or filter clogged with dirt or debris; blocked vent hose or canister filter; wiring problem to the pump module. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.