Home › Code lookup › P043F
Powertrain code · Emissions

P043F Evaporative Emission System Leak Detection Reference Orifice High Flow

How urgent? Book a check when convenient

What it means

The computer sees more air flowing through the leak test reference hole than it should, which usually means the leak detection pump or its valve is faulty.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect hoses at the pump module for cracks or loose fittings
  2. Run the EVAP leak test with a scan tool and watch pump pressure readings

Signs you may notice

  • Check engine light on
  • No change in how the car drives
  • Other EVAP codes may set at the same time

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed leak detection pump module
  • CommonLeaking hose or seal at the pump module
  • PossibleWiring problem to the pump module

Typical repair once the cause is confirmed

Usually a new leak detection pump module.

Repair costInsufficient verified pricing for this vehicle and repair
Replace EVAP leak detection pump module. Prepare an itemized shop request.

Where it shows up

  • Often seen on Toyota and Lexus models that use a canister-mounted leak detection pump

Common questions

What does P043F mean?

The computer sees more air flowing through the leak test reference hole than it should, which usually means the leak detection pump or its valve is faulty.

Can I drive with code P043F?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P043F?

Common possibilities to test include: failed leak detection pump module; leaking hose or seal at the pump module; wiring problem to the pump module. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.