Home › Code lookup › P0443
Powertrain code · Emissions

P0443 Evaporative Emission Control System Purge Control Valve Circuit

How urgent? Book a check when convenient

What it means

The computer found an electrical problem with the purge valve, the part that lets stored fuel vapors be drawn into the engine.

Can I keep driving?

Usually safe to keep driving. If the engine idles rough or is hard to start after refueling, get it checked sooner. If you smell strong raw fuel or see a leak, stop and get it looked at.

What to test before replacing parts

Check the fuse, connector and wiring to the purge valve, measure the solenoid's resistance, and confirm the computer's command before replacing the valve or computer.

  1. Measure the purge valve resistance
  2. Check for power at the purge valve connector with the key on
  3. Inspect wiring near hot engine parts

Signs you may notice

  • Check engine light on
  • Usually no change in driving
  • Possible rough idle or hard start after refueling

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed purge valve solenoid
  • CommonDamaged connector at the purge valve
  • CommonBroken or shorted wiring
  • PossibleBlown fuse
  • PossibleEngine computer driver fault

Typical repair once the cause is confirmed

Usually a new purge valve or a wiring repair.

Repair costInsufficient verified pricing for this vehicle and repair
Replace EVAP purge valve. Prepare an itemized shop request.
Walk through it step by step: Check engine light on →

Common questions

What does P0443 mean?

The computer found an electrical problem with the purge valve, the part that lets stored fuel vapors be drawn into the engine.

Can I drive with code P0443?

Usually safe to keep driving. If the engine idles rough or is hard to start after refueling, get it checked sooner. If you smell strong raw fuel or see a leak, stop and get it looked at.

What causes P0443?

Common possibilities to test include: failed purge valve solenoid; damaged connector at the purge valve; broken or shorted wiring; blown fuse. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.