Home › Code lookup › P0453
Powertrain code · Emissions

P0453 Evaporative Emission Control System Pressure Sensor High Input

How urgent? Book a check when convenient

What it means

The fuel tank pressure sensor signal is higher than it should be, usually from an open wire, a bad sensor or a blocked vent.

Can I keep driving?

Usually safe to keep driving. If the pump nozzle keeps clicking off, don't force extra fuel in. If you smell strong raw fuel or see fuel leaking, stop driving and get it checked right away because of the fire risk.

What to test before replacing parts

Check the sensor's signal and ground wires for an open, inspect the connector, and make sure the vent valve and hose aren't blocked before replacing the sensor.

  1. Check the sensor reading with the gas cap off
  2. Inspect the vent valve and filter for blockage
  3. Check the sensor ground and wiring

Signs you may notice

  • Check engine light on
  • No change in how the car drives
  • Possible trouble filling the tank

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed fuel tank pressure sensor
  • CommonOpen signal or ground wire
  • CommonBlocked vent valve or vent hose
  • PossibleCorroded connector
  • PossibleSaturated charcoal canister

Typical repair once the cause is confirmed

Usually a new fuel tank pressure sensor, or clearing a blocked vent.

Repair costInsufficient verified pricing for this vehicle and repair
Replace fuel tank pressure sensor. Prepare an itemized shop request.
Walk through it step by step: Check engine light on →

Common questions

What does P0453 mean?

The fuel tank pressure sensor signal is higher than it should be, usually from an open wire, a bad sensor or a blocked vent.

Can I drive with code P0453?

Usually safe to keep driving. If the pump nozzle keeps clicking off, don't force extra fuel in. If you smell strong raw fuel or see fuel leaking, stop driving and get it checked right away because of the fire risk.

What causes P0453?

Common possibilities to test include: failed fuel tank pressure sensor; open signal or ground wire; blocked vent valve or vent hose; corroded connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.