Home › Code lookup › P0462
Powertrain code · Fuel and air

P0462 Fuel Level Sensor "A" Circuit Low

How urgent? Book a check when convenient

What it means

The fuel level sensor signal is lower than it should ever be, usually from a short to ground or a failed sending unit.

Can I keep driving?

The car usually drives normally, but you can't trust the fuel gauge. Running out of fuel can leave you stranded somewhere unsafe, so track miles since your last fill-up and refuel early. Get it repaired when you can.

What to test before replacing parts

Check the signal wire for a short to ground, inspect the connector at the tank, and measure the sender's resistance before replacing the sender or cluster.

  1. Compare the gauge reading with the scan tool fuel level reading
  2. Check the wiring and connector at the top of the fuel tank
  3. Measure the sending unit resistance at empty and full

Signs you may notice

  • Check engine light on
  • Fuel gauge reads wrong, stuck, or jumps around
  • Low fuel warning comes on at the wrong time

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed fuel level sending unit
  • CommonSignal wire shorted to ground
  • CommonDamaged connector at the fuel tank
  • PossibleInstrument cluster or computer fault

Typical repair once the cause is confirmed

Usually a new fuel level sending unit or a wiring repair.

Repair costInsufficient verified pricing for this vehicle and repair
Replace fuel level sending unit. Prepare an itemized shop request.

Common questions

What does P0462 mean?

The fuel level sensor signal is lower than it should ever be, usually from a short to ground or a failed sending unit.

Can I drive with code P0462?

The car usually drives normally, but you can't trust the fuel gauge. Running out of fuel can leave you stranded somewhere unsafe, so track miles since your last fill-up and refuel early. Get it repaired when you can.

What causes P0462?

Common possibilities to test include: failed fuel level sending unit; signal wire shorted to ground; damaged connector at the fuel tank; instrument cluster or computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.