Home › Code lookup › P0463
Powertrain code · Fuel and air

P0463 Fuel Level Sensor "A" Circuit High

How urgent? Book a check when convenient

What it means

The fuel level sensor signal is higher than it should ever be, usually from an open wire or a failed sending unit.

Can I keep driving?

The car usually drives normally, but you can't trust the fuel gauge. Running out of fuel can leave you stranded somewhere unsafe, so track miles since your last fill-up and refuel early. Get it repaired when you can.

What to test before replacing parts

Check the signal and ground wires for an open, make sure the tank connector is plugged in and clean, and measure the sender's resistance before replacing it.

  1. Compare the gauge reading with the scan tool fuel level reading
  2. Check the wiring and connector at the top of the fuel tank
  3. Measure the sending unit resistance at empty and full

Signs you may notice

  • Check engine light on
  • Fuel gauge reads wrong, stuck, or jumps around
  • Low fuel warning comes on at the wrong time

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed fuel level sending unit
  • CommonOpen signal or ground wire
  • CommonCorroded or unplugged connector at the tank
  • PossiblePoor ground connection

Typical repair once the cause is confirmed

Usually a new fuel level sending unit or a wiring repair.

Repair costInsufficient verified pricing for this vehicle and repair
Replace fuel level sending unit. Prepare an itemized shop request.

Common questions

What does P0463 mean?

The fuel level sensor signal is higher than it should ever be, usually from an open wire or a failed sending unit.

Can I drive with code P0463?

The car usually drives normally, but you can't trust the fuel gauge. Running out of fuel can leave you stranded somewhere unsafe, so track miles since your last fill-up and refuel early. Get it repaired when you can.

What causes P0463?

Common possibilities to test include: failed fuel level sending unit; open signal or ground wire; corroded or unplugged connector at the tank; poor ground connection. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.