Home › Code lookup › P0484
Powertrain code · Cooling

P0484 Cooling Fan Circuit Over Current

How urgent? Get it checked in the next few days

What it means

The cooling fan circuit is drawing more current than it should, which usually means the fan motor is binding or shorted.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Spin the fan by hand with the engine off and key out to feel for binding
  2. Measure fan current draw

Signs you may notice

  • Check engine light on
  • Fan may not run
  • Engine may run hot in traffic

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWorn or seized fan motor
  • CommonDebris jamming the fan blade
  • PossibleShorted wiring

Typical repair once the cause is confirmed

Usually a new cooling fan motor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace cooling fan motor or fan assembly. Prepare an itemized shop request.
Walk through it step by step: Overheats in traffic or at idle →

Common questions

What does P0484 mean?

The cooling fan circuit is drawing more current than it should, which usually means the fan motor is binding or shorted.

Can I drive with code P0484?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0484?

Common possibilities to test include: worn or seized fan motor; debris jamming the fan blade; shorted wiring. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.