Home › Code lookup › P04A6
Powertrain code · Engine

P04A6 Exhaust Pressure Control Valve "B" Position Sensor/Switch Circuit

How urgent? Book a check when convenient

What it means

The computer sees an electrical problem with the sensor that reports where the second exhaust pressure control valve is.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Command the valve with a scan tool and watch its position reading
  2. Inspect the position sensor connector and wiring

Signs you may notice

  • Check engine light on
  • Possible loss of power on diesels
  • Slower warm-up in cold weather

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed position sensor (often built into the valve actuator)
  • CommonDamaged wiring or connector
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually a new valve actuator or a wiring repair.

Repair costInsufficient verified pricing for this vehicle and repair
Replace exhaust pressure control valve. Prepare an itemized shop request.

Common questions

What does P04A6 mean?

The computer sees an electrical problem with the sensor that reports where the second exhaust pressure control valve is.

Can I drive with code P04A6?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P04A6?

Common possibilities to test include: failed position sensor (often built into the valve actuator); damaged wiring or connector; engine computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.