P0606 Control Module Processor
What it means
The engine computer's self-test found a problem with its own processor, the chip that runs the engine.
Can I keep driving?
Be cautious: an engine computer fault can cause sudden limp mode, stalling or erratic shifting. If you've had stalling or power loss, avoid highways and consider a tow. If it runs normally, get it checked soon.
What to test before replacing parts
Check system voltage and the computer's power and grounds, look for a software update, and check for water damage or a shorted sensor before replacing the engine computer.
- Test the battery and charging system
- Check the computer power and ground circuits and connectors
- Check for software updates or service bulletins
- Clear the code and see if it returns
Signs you may notice
- Check engine light on
- Reduced power or limp mode
- Stalling or no start
- Erratic shifting on some vehicles
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonInternal engine computer fault
- CommonLow system voltage or poor power and ground connections
- PossibleComputer software that needs an update
- PossibleWater damage or corrosion at the computer connector
- PossibleShorted sensor or actuator dragging down computer circuits
Typical repair once the cause is confirmed
Fix any voltage or ground problem first; if the code returns, the computer usually needs reprogramming or replacement.
Known on these vehicles
Common questions
What does P0606 mean?
The engine computer's self-test found a problem with its own processor, the chip that runs the engine.
Can I drive with code P0606?
Be cautious: an engine computer fault can cause sudden limp mode, stalling or erratic shifting. If you've had stalling or power loss, avoid highways and consider a tow. If it runs normally, get it checked soon.
What causes P0606?
Common possibilities to test include: internal engine computer fault; low system voltage or poor power and ground connections; computer software that needs an update; water damage or corrosion at the computer connector. A shop should confirm the cause before replacing parts.