Home › Code lookup › P060A
Powertrain code · Computer

P060A Internal Control Module Monitoring Processor Performance

How urgent? Get it checked in the next few days

What it means

The engine computer has a second, watchdog processor that checks the main one, and it found a fault.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Test the battery and charging system
  2. Check the computer power and ground circuits and connectors
  3. Check for manufacturer software updates or service bulletins

Signs you may notice

  • Check engine light on
  • Possible reduced power, stalling or no start
  • Other warning lights may come on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLow battery voltage or poor power or ground connections at the computer
  • CommonInternal computer fault
  • PossibleComputer software that needs an update or reprogramming
  • PossibleWater damage or corrosion at the computer connector

Typical repair once the cause is confirmed

Fix any power or ground problem first; otherwise the computer may need reprogramming or replacement (a new one usually must be programmed to the car).

Known on these vehicles

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P060A mean?

The engine computer has a second, watchdog processor that checks the main one, and it found a fault.

Can I drive with code P060A?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P060A?

Common possibilities to test include: low battery voltage or poor power or ground connections at the computer; internal computer fault; computer software that needs an update or reprogramming; water damage or corrosion at the computer connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.