P2518 A/C Refrigerant Pressure Sensor "B" Circuit High
What it means
The computer is watching the second A/C refrigerant pressure sensor and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This sensor tells the computer how much pressure is in the A/C system so it can protect the compressor.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the wiring and ground connection for the second A/C refrigerant pressure sensor
- Check for wires melted or rubbed together in the harness
- Measure the circuit with a meter before replacing parts
Signs you may notice
- Check engine light on
- A/C may blow warm or cut out
- Cooling fans may run more than usual
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonSignal wire shorted to voltage or a broken ground wire
- CommonFailed second A/C refrigerant pressure sensor
- PossibleCorroded or loose connector
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Repair the open ground or shorted wire; if the wiring is fine, replace the second A/C refrigerant pressure sensor.
Common questions
What does P2518 mean?
The computer is watching the second A/C refrigerant pressure sensor and is reading a voltage that is higher than it should be, which often means a broken ground or a short to power. This sensor tells the computer how much pressure is in the A/C system so it can protect the compressor.
Can I drive with code P2518?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2518?
Common possibilities to test include: signal wire shorted to voltage or a broken ground wire; failed second a/c refrigerant pressure sensor; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.