Home › Code lookup › P2519
Powertrain code · Body

P2519 A/C Request "A" Circuit

How urgent? Book a check when convenient

What it means

The computer is watching the A/C request signal and has spotted an electrical fault. This is the signal from the A/C controls asking the engine computer to turn on the compressor.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the connector and wiring for the A/C request signal, checking for damage, corrosion or a loose fit
  2. Check power, ground and signal with a meter
  3. Clear the code and see if it comes back

Signs you may notice

  • Check engine light on
  • A/C may not turn on or may not shut off
  • Idle may change when A/C is switched

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, loose or corroded connector at the climate control switch or module
  • CommonBroken or chafed wire in the A/C request signal
  • CommonFailed climate control switch or module
  • PossibleMissing reference voltage or ground from the computer
  • PossibleControl module fault (rare)

Typical repair once the cause is confirmed

Repair the wiring or connector if it is damaged; otherwise replace the climate control switch or module.

Walk through it step by step: A/C blows warm air →

Common questions

What does P2519 mean?

The computer is watching the A/C request signal and has spotted an electrical fault. This is the signal from the A/C controls asking the engine computer to turn on the compressor.

Can I drive with code P2519?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2519?

Common possibilities to test include: unplugged, loose or corroded connector at the climate control switch or module; broken or chafed wire in the a/c request signal; failed climate control switch or module; missing reference voltage or ground from the computer. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.