P2520 A/C Request "A" Circuit Low
What it means
The computer is watching the A/C request signal and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This is the signal from the A/C controls asking the engine computer to turn on the compressor.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the wiring in the A/C request signal for rubbed-through insulation touching metal
- Check the wiring for a short to ground with a meter
- Clear the code and see if it returns right away
Signs you may notice
- Check engine light on
- A/C may not turn on or may not shut off
- Idle may change when A/C is switched
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonSignal wire in the A/C request signal shorted to ground or open
- CommonFailed climate control switch or module
- PossibleCorroded or loose connector
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Fix any shorted wiring first; if the wiring tests good, replace the climate control switch or module.
Common questions
What does P2520 mean?
The computer is watching the A/C request signal and is reading a voltage that is lower than it should be, which often means a short to ground or a failed part. This is the signal from the A/C controls asking the engine computer to turn on the compressor.
Can I drive with code P2520?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2520?
Common possibilities to test include: signal wire in the a/c request signal shorted to ground or open; failed climate control switch or module; corroded or loose connector; control module fault (rare). A shop should confirm the cause before replacing parts.