P2522 A/C Request "B" Circuit
What it means
The computer is watching the A/C request signal and has spotted an electrical fault. This is the signal from the A/C controls asking the engine computer to turn on the compressor.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Look over the connector and wiring for the A/C request signal, checking for damage, corrosion or a loose fit
- Check power, ground and signal with a meter
- Clear the code and see if it comes back
Signs you may notice
- Check engine light on
- A/C may not turn on or may not shut off
- Idle may change when A/C is switched
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonUnplugged, loose or corroded connector at the climate control switch or module
- CommonBroken or chafed wire in the A/C request signal
- CommonFailed climate control switch or module
- PossibleMissing reference voltage or ground from the computer
- PossibleControl module fault (rare)
Typical repair once the cause is confirmed
Repair the wiring or connector if it is damaged; otherwise replace the climate control switch or module.
Common questions
What does P2522 mean?
The computer is watching the A/C request signal and has spotted an electrical fault. This is the signal from the A/C controls asking the engine computer to turn on the compressor.
Can I drive with code P2522?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2522?
Common possibilities to test include: unplugged, loose or corroded connector at the climate control switch or module; broken or chafed wire in the a/c request signal; failed climate control switch or module; missing reference voltage or ground from the computer. A shop should confirm the cause before replacing parts.