Ford Crown Victoriaproblems, repair costs and recalls
Problems reported across 1996–2011. Pick your model year below to see what applies to your vehicle.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
14 documented issues across all years, most serious first.
Cracked plastic intake manifold coolant passage
- What you'll notice
- Coolant leaking at the front of the engine near the thermostat housing, a sweet smell, a dropping coolant level and possible overheating.
- Why it happens
- The all-plastic intake manifold's coolant crossover can crack from repeated heating and cooling, and the heater hose and sensor fittings can loosen. Ford changed to an aluminum crossover for 2002.
- What to do
- Watch the temperature gauge and pull over if it rises. Replace the manifold with the updated design.
Cruise control deactivation switch can start an underhood fire (recall)
- What you'll notice
- Smoke or a burning smell from the engine bay, sometimes even with the car parked and switched off; cruise control may stop working.
- Why it happens
- The cruise control shut-off switch mounted on the brake master cylinder can leak brake fluid internally, overheat and burn. Ford first disconnected the switch, then fitted a fused wiring harness, and recalled some cars again because the first harness was wired with the wrong polarity.
- What to do
- Check the VIN for recalls 07V-336 and 08V-051. Until both are done, park away from buildings, and if you see smoke or smell burning, stop and shut the engine off.
Headlights suddenly go out (recall)
- What you'll notice
- All headlights shut off without warning while driving, sometimes coming back after restarting.
- Why it happens
- Solder joints inside the lighting control module crack. After a federal investigation, Ford recalled the cars and replaces the module.
- What to do
- Check your VIN for recall 15V-861 and get the free module. Avoid night driving until it is fixed.
Rear wheel bearing and axle shaft wear on police and fleet cars (recall)
- What you'll notice
- Growling or grinding from the rear axle that gets louder with speed. In severe cases an axle can break and a wheel can come loose.
- Why it happens
- Heavy police, taxi and fleet loads overloaded the rear wheel bearings and axle shafts. Ford recalled these cars to replace bearings, seals and shafts.
- What to do
- Stop driving if the rear end grinds loudly. Check the VIN for recall 04V-328, especially on ex-police or taxi cars.
Steel wheels can crack near the weld (police and taxi)
- What you'll notice
- A tire that keeps losing air, a vibration, or a visible crack around the inner rim of a steel wheel.
- Why it happens
- Steel wheels on police and taxi cars could crack along the weld. Ford recalled certain wheels, added extended coverage, and switched to a stronger wheel.
- What to do
- Inspect steel wheels on ex-police or taxi cars and replace any cracked wheel before driving further. Check the VIN for recall 03V-279.
Insulation pad can sag onto the catalytic converter (police and taxi recall)
- What you'll notice
- Smoke or a burning smell from under the car or the front floor area, especially after long idling.
- Why it happens
- On police and taxi versions a sound insulating pad can sag in high heat and touch the catalytic converter, which can char it and start a fire. Ford recalled these cars to fit a revised pad.
- What to do
- If you see smoke or smell burning, stop and shut the engine off. Have the VIN checked for the open recall on ex-police or taxi cars.
Rusted steering shaft can cause loss of steering (recall)
- What you'll notice
- Stiff, notchy or clunking steering, or a steering wheel that suddenly stops controlling the front wheels.
- Why it happens
- Road-salt corrosion can seize the lower intermediate steering shaft, which can collapse the upper shaft and separate the column bearing. Ford recalled cars from salt-belt states, then recalled some again for incorrect repairs.
- What to do
- Stop driving if the steering feels unusual. Check the VIN for recalls 13V-385 and 14V-704 and get the free repair.
Transmission slips from a cracked forward clutch cylinder
- What you'll notice
- Slipping, flaring between gears, delayed engagement or loss of forward drive.
- Why it happens
- The forward clutch cylinder inside the 4-speed automatic can crack. Ford covered the repair under an extended coverage program (06B36).
- What to do
- Have the transmission checked promptly and ask a Ford dealer whether the extended coverage was applied to this VIN.
Coolant leak where the intake manifold meets the aluminum crossover
- What you'll notice
- Coolant slowly disappearing, a sweet smell, or wetness and crust at the front of the engine near the thermostat housing. Coolant can pool in the valley under the manifold where it is hard to see.
- Why it happens
- From 2002 Ford added an aluminum coolant crossover to the plastic intake manifold. That cut down on cracking, but the joint between the aluminum and plastic parts tends to seep as the engine ages. The gasket is not sold on its own, so the usual repair is a new manifold.
- What to do
- Keep the coolant topped up and watch the temperature gauge. Have the leak confirmed and the manifold replaced before it gets worse, and pull over if the engine starts to overheat.
Automatic transmission slipping or failure
- What you'll notice
- Slipping, harsh or late shifts, loss of overdrive, or the car not wanting to move in Drive or Reverse.
- Why it happens
- The 4-speed automatic is one of the most reported repairs on this car, and a failing front pump is a common cause. Police, taxi and high-idle use add heat and wear.
- What to do
- Have the fluid and shifting checked at the first sign of slipping. Continuing to drive a slipping transmission usually turns a smaller repair into a rebuild.
Loss of overdrive on police and long-wheelbase taxi cars
- What you'll notice
- The transmission will not shift into overdrive, so the engine revs higher at highway speed.
- Why it happens
- Ford issued service bulletins for police and taxi cars that lose overdrive, with a specific diagnosis and repair procedure.
- What to do
- Have a Ford dealer or transmission shop check the bulletins (TSB 17785 and 04163) against the car before replacing parts.
Power window stops working from a worn regulator
- What you'll notice
- A grinding or clicking from inside the door, a window that creeps down or jams part way, or one window that stops moving while the others still work.
- Why it happens
- The plastic parts and cable in the window regulator wear out and let go, so the motor turns but the glass does not move.
- What to do
- Get the regulator replaced when a window sticks, especially before winter, since the glass can drop into the door and leave the car open to weather.
Front suspension and steering parts wear out
- What you'll notice
- Clunks over bumps, wandering or loose steering, uneven front tire wear, and a shimmy you feel through the wheel.
- Why it happens
- Ball joints, stabilizer bar links and the steering idler arm carry a heavy front end and wear out, which lets the front wheels move around.
- What to do
- Have the front end inspected and the worn parts replaced; it is a common repair on these cars and it brings the steering and tire wear back to normal.
Instrument cluster display flickers
- What you'll notice
- The electronic display in the gauge cluster flickers or blinks.
- Why it happens
- Ford released a service bulletin covering a flickering electronic instrument cluster display on these cars.
- What to do
- Mention TSB 17295 to the shop so they follow the published fix.
Repair prices for your Ford Crown Victoria
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace intake manifold
- Replace cruise deactivation switch and add fused jumper
- Replace lighting control module
- Replace rear axle shaft, bearing and seal
- Replace cracked steel wheel and mount tire
- Remove or replace floor insulation pad
- Rebuild or replace transmission with remanufactured unit
- Replace lower intermediate steering shaft
- Replace intake manifold and gaskets
- Replace transmission with a remanufactured unit
- Rebuild transmission overdrive section
- Repair or replace instrument cluster
- Replace power window regulator and motor
- Replace front ball joints and stabilizer bar links
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.