Your 2003 Ford Crown Victoriaproblems, repair costs and recalls
What we've documented about the 2003 Ford Crown Victoria: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2003 Ford Crown Victoria
6 documented issues apply to 2003, most serious first.
Headlights suddenly go out (recall)
- What you'll notice
- All headlights shut off without warning while driving, sometimes coming back after restarting.
- Why it happens
- Solder joints inside the lighting control module crack. After a federal investigation, Ford recalled the cars and replaces the module.
- What to do
- Check your VIN for recall 15V-861 and get the free module. Avoid night driving until it is fixed.
Rear wheel bearing and axle shaft wear on police and fleet cars (recall)
- What you'll notice
- Growling or grinding from the rear axle that gets louder with speed. In severe cases an axle can break and a wheel can come loose.
- Why it happens
- Heavy police, taxi and fleet loads overloaded the rear wheel bearings and axle shafts. Ford recalled these cars to replace bearings, seals and shafts.
- What to do
- Stop driving if the rear end grinds loudly. Check the VIN for recall 04V-328, especially on ex-police or taxi cars.
Steel wheels can crack near the weld (police and taxi)
- What you'll notice
- A tire that keeps losing air, a vibration, or a visible crack around the inner rim of a steel wheel.
- Why it happens
- Steel wheels on police and taxi cars could crack along the weld. Ford recalled certain wheels, added extended coverage, and switched to a stronger wheel.
- What to do
- Inspect steel wheels on ex-police or taxi cars and replace any cracked wheel before driving further. Check the VIN for recall 03V-279.
Insulation pad can sag onto the catalytic converter (police and taxi recall)
- What you'll notice
- Smoke or a burning smell from under the car or the front floor area, especially after long idling.
- Why it happens
- On police and taxi versions a sound insulating pad can sag in high heat and touch the catalytic converter, which can char it and start a fire. Ford recalled these cars to fit a revised pad.
- What to do
- If you see smoke or smell burning, stop and shut the engine off. Have the VIN checked for the open recall on ex-police or taxi cars.
Coolant leak where the intake manifold meets the aluminum crossover
- What you'll notice
- Coolant slowly disappearing, a sweet smell, or wetness and crust at the front of the engine near the thermostat housing. Coolant can pool in the valley under the manifold where it is hard to see.
- Why it happens
- From 2002 Ford added an aluminum coolant crossover to the plastic intake manifold. That cut down on cracking, but the joint between the aluminum and plastic parts tends to seep as the engine ages. The gasket is not sold on its own, so the usual repair is a new manifold.
- What to do
- Keep the coolant topped up and watch the temperature gauge. Have the leak confirmed and the manifold replaced before it gets worse, and pull over if the engine starts to overheat.
Automatic transmission slipping or failure
- What you'll notice
- Slipping, harsh or late shifts, loss of overdrive, or the car not wanting to move in Drive or Reverse.
- Why it happens
- The 4-speed automatic is one of the most reported repairs on this car, and a failing front pump is a common cause. Police, taxi and high-idle use add heat and wear.
- What to do
- Have the fluid and shifting checked at the first sign of slipping. Continuing to drive a slipping transmission usually turns a smaller repair into a rebuild.
Repair prices for your 2003 Ford Crown Victoria
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace lighting control module
- Replace rear axle shaft, bearing and seal
- Replace cracked steel wheel and mount tire
- Remove or replace floor insulation pad
- Replace intake manifold and gaskets
- Replace transmission with a remanufactured unit
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…