Home › Code lookup › P0001
Powertrain code · Fuel and air

P0001 Fuel Volume Regulator Control Circuit/Open

How urgent? Get it checked in the next few days

What it means

The fuel volume regulator is a small electric valve, usually on the high-pressure fuel pump, that meters how much fuel is sent to the injectors. The computer has seen an open or broken connection in its control circuit. It is mostly found on diesels and some direct-injection gas engines.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the regulator connector and wiring for damage or corrosion
  2. Measure the regulator coil resistance and compare to spec
  3. Check the power and control signal at the connector

Signs you may notice

  • Check engine light on
  • Hard starting or long cranking
  • Engine may stall, lose power or go into limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonDamaged, chafed or corroded wiring to the regulator
  • CommonLoose or corroded connector at the regulator
  • CommonFailed fuel volume regulator (open or shorted coil)
  • PossibleEngine computer driver fault

Typical repair once the cause is confirmed

Usually a wiring or connector repair, or a new fuel volume regulator if its coil has failed.

Repair costInsufficient verified pricing for this vehicle and repair
Replace fuel volume regulator. Prepare an itemized shop request.
Walk through it step by step: Check engine light on →

Common questions

What does P0001 mean?

The fuel volume regulator is a small electric valve, usually on the high-pressure fuel pump, that meters how much fuel is sent to the injectors. The computer has seen an open or broken connection in its control circuit. It is mostly found on diesels and some direct-injection gas engines.

Can I drive with code P0001?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0001?

Common possibilities to test include: damaged, chafed or corroded wiring to the regulator; loose or corroded connector at the regulator; failed fuel volume regulator (open or shorted coil); engine computer driver fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.