Home › Code lookup › P0009
Powertrain code · Engine

P0009 Engine Position System Performance (Bank 2)

How urgent? Get it checked in the next few days

What it means

The computer compares the crankshaft and camshaft sensor signals and found that the timing between them on bank 2 is off. This often means the timing chain has stretched.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the oil level and condition
  2. Check for related codes such as P0008 or P0016 to P0019
  3. Have cam-to-crank deviation values checked with a scan tool

Signs you may notice

  • Check engine light on
  • Rough idle or rattle at startup
  • Possible loss of power or fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonStretched timing chain
  • CommonLow oil level or long oil change intervals
  • CommonWorn timing chain guides or tensioner
  • PossibleFaulty camshaft or crankshaft sensor

Typical repair once the cause is confirmed

Usually a timing chain set with guides and tensioners.

Repair costInsufficient verified pricing for this vehicle and repair
Replace timing chain set. Prepare an itemized shop request.

Where it shows up

  • Often sets along with P0008 on the GM 3.6L V6 when the timing chains stretch

Known on these vehicles

Walk through it step by step: Check engine light on →

Common questions

What does P0009 mean?

The computer compares the crankshaft and camshaft sensor signals and found that the timing between them on bank 2 is off. This often means the timing chain has stretched.

Can I drive with code P0009?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0009?

Common possibilities to test include: stretched timing chain; low oil level or long oil change intervals; worn timing chain guides or tensioner; faulty camshaft or crankshaft sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.