P0003 Fuel Volume Regulator Control Circuit Low
What it means
The fuel volume regulator is a small electric valve, usually on the high-pressure fuel pump, that meters how much fuel is sent to the injectors. The computer has seen a voltage that is lower than expected in its control circuit. It is mostly found on diesels and some direct-injection gas engines.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the regulator connector and wiring for damage or corrosion
- Measure the regulator coil resistance and compare to spec
- Check the power and control signal at the connector
Signs you may notice
- Check engine light on
- Hard starting or long cranking
- Engine may stall, lose power or go into limp mode
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonDamaged, chafed or corroded wiring to the regulator
- CommonLoose or corroded connector at the regulator
- CommonFailed fuel volume regulator (open or shorted coil)
- PossibleEngine computer driver fault
Typical repair once the cause is confirmed
Usually a wiring or connector repair, or a new fuel volume regulator if its coil has failed.
Common questions
What does P0003 mean?
The fuel volume regulator is a small electric valve, usually on the high-pressure fuel pump, that meters how much fuel is sent to the injectors. The computer has seen a voltage that is lower than expected in its control circuit. It is mostly found on diesels and some direct-injection gas engines.
Can I drive with code P0003?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0003?
Common possibilities to test include: damaged, chafed or corroded wiring to the regulator; loose or corroded connector at the regulator; failed fuel volume regulator (open or shorted coil); engine computer driver fault. A shop should confirm the cause before replacing parts.