Home › Code lookup › P0002
Powertrain code · Fuel and air

P0002 Fuel Volume Regulator Control Circuit Range/Performance

How urgent? Get it checked in the next few days

What it means

The fuel volume regulator is a small electric valve, usually on the high-pressure fuel pump, that meters how much fuel is sent to the injectors. The computer has seen a reading that does not match what it commanded in its control circuit. It is mostly found on diesels and some direct-injection gas engines.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Replace the fuel filter if it is due and check for water in the fuel
  2. Check low-side fuel supply pressure
  3. Compare commanded and actual rail pressure with a scan tool

Signs you may notice

  • Check engine light on
  • Hard starting or long cranking
  • Engine may stall, lose power or go into limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonContaminated or low-quality fuel making the regulator stick
  • CommonFaulty fuel volume regulator
  • CommonClogged fuel filter or low supply pressure
  • PossibleWorn high-pressure fuel pump
  • PossibleDamaged wiring or loose connector

Typical repair once the cause is confirmed

Often a new fuel filter and, if needed, a new fuel volume regulator. A worn high-pressure pump is the less common but costlier cause.

Repair costInsufficient verified pricing for this vehicle and repair
Replace fuel volume regulator. Prepare an itemized shop request.
Walk through it step by step: Hard to start when hot →

Common questions

What does P0002 mean?

The fuel volume regulator is a small electric valve, usually on the high-pressure fuel pump, that meters how much fuel is sent to the injectors. The computer has seen a reading that does not match what it commanded in its control circuit. It is mostly found on diesels and some direct-injection gas engines.

Can I drive with code P0002?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0002?

Common possibilities to test include: contaminated or low-quality fuel making the regulator stick; faulty fuel volume regulator; clogged fuel filter or low supply pressure; worn high-pressure fuel pump. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.