Home › Code lookup › P0612
Powertrain code · Fuel and air

P0612 Fuel Injector Control Module Relay Control

How urgent? Get it checked in the next few days

What it means

The computer found a problem, such as a broken connection, in the circuit it uses to control the fuel injector control module relay. This part powers the module that fires the fuel injectors.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the fuel injector control module relay wiring and connector for damage or corrosion
  2. Check related fuses and relays
  3. Test the fuel injector control module relay with a meter or scan tool and compare with spec

Signs you may notice

  • Hard starting or no start
  • Possible stalling
  • Check engine light on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty fuel injector control module relay
  • CommonBroken wire or loose or corroded connector
  • PossibleBlown fuse or failed relay
  • PossibleComputer driver circuit fault (rare)

Typical repair once the cause is confirmed

Usually a wiring or connector repair, or a new fuel injector control module relay if it tests bad.

Walk through it step by step: Car won't start →

Common questions

What does P0612 mean?

The computer found a problem, such as a broken connection, in the circuit it uses to control the fuel injector control module relay. This part powers the module that fires the fuel injectors.

Can I drive with code P0612?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0612?

Common possibilities to test include: faulty fuel injector control module relay; broken wire or loose or corroded connector; blown fuse or failed relay; computer driver circuit fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.