Home › Code lookup › P0613
Powertrain code · Transmission

P0613 TCM Processor

How urgent? Get it checked in the next few days

What it means

The transmission computer's self-test found a problem with its own processor.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Test the battery and charging system
  2. Check transmission computer power and ground connections
  3. Check for transmission computer software updates

Signs you may notice

  • Check engine light on
  • Transmission stuck in one gear or limp mode
  • Harsh or erratic shifting

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLow battery voltage or poor power or ground connections at the computer
  • CommonInternal computer fault
  • PossibleComputer software that needs an update or reprogramming
  • PossibleWater damage or corrosion at the computer connector

Typical repair once the cause is confirmed

Fix any power or ground problem first; otherwise the transmission computer needs reprogramming or replacement.

Walk through it step by step: Harsh or late shifting →

Common questions

What does P0613 mean?

The transmission computer's self-test found a problem with its own processor.

Can I drive with code P0613?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0613?

Common possibilities to test include: low battery voltage or poor power or ground connections at the computer; internal computer fault; computer software that needs an update or reprogramming; water damage or corrosion at the computer connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.