Home › Code lookup › P0614
Powertrain code · Computer

P0614 ECM / TCM Incompatible

How urgent? Get it checked in the next few days

What it means

The engine computer and transmission computer don't match each other, usually after one was replaced or reprogrammed.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Ask whether either computer was recently replaced or updated
  2. Confirm part numbers and update software on both computers

Signs you may notice

  • Check engine light on
  • Transmission may be in limp mode
  • Engine may not start on some vehicles

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWrong engine or transmission computer installed
  • CommonComputer not programmed after replacement
  • PossibleMismatched software versions
  • PossibleInternal computer fault

Typical repair once the cause is confirmed

Usually programming both computers with matching software, or installing the correct part.

Common questions

What does P0614 mean?

The engine computer and transmission computer don't match each other, usually after one was replaced or reprogrammed.

Can I drive with code P0614?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0614?

Common possibilities to test include: wrong engine or transmission computer installed; computer not programmed after replacement; mismatched software versions; internal computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.