Home › Code lookup › P0615
Powertrain code · Electrical

P0615 Starter Relay Circuit

How urgent? Get it checked in the next few days

What it means

The computer found a problem, such as a broken connection, in the circuit it uses to control the starter relay. This part switches power to the starter when you turn the key or press start.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the starter relay wiring and connector for damage or corrosion
  2. Check related fuses and relays
  3. Test the starter relay with a meter or scan tool and compare with spec

Signs you may notice

  • Engine may not crank
  • Clicking with no crank, or cranking only sometimes
  • Check engine light on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty starter relay
  • CommonBroken wire or loose or corroded connector
  • PossibleBlown fuse or failed relay
  • PossibleComputer driver circuit fault (rare)

Typical repair once the cause is confirmed

Usually a wiring or connector repair, or a new starter relay if it tests bad.

Walk through it step by step: Car won't start →

Common questions

What does P0615 mean?

The computer found a problem, such as a broken connection, in the circuit it uses to control the starter relay. This part switches power to the starter when you turn the key or press start.

Can I drive with code P0615?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0615?

Common possibilities to test include: faulty starter relay; broken wire or loose or corroded connector; blown fuse or failed relay; computer driver circuit fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.