Home › Code lookup › P0616
Powertrain code · Electrical

P0616 Starter Relay Circuit Low

How urgent? Get it checked in the next few days

What it means

The computer sees lower voltage than expected in the circuit that controls the starter relay, often from a wire shorted to ground. This part switches power to the starter when you turn the key or press start.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the starter relay wiring and connector for damage or corrosion
  2. Check related fuses and relays
  3. Test the starter relay with a meter or scan tool and compare with spec

Signs you may notice

  • Engine may not crank
  • Clicking with no crank, or cranking only sometimes
  • Check engine light on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonControl wire shorted to ground
  • CommonFaulty starter relay
  • PossibleCorroded connector
  • PossibleComputer driver circuit fault (rare)

Typical repair once the cause is confirmed

Usually a wiring or connector repair, or a new starter relay if it tests bad.

Walk through it step by step: Car won't start →

Common questions

What does P0616 mean?

The computer sees lower voltage than expected in the circuit that controls the starter relay, often from a wire shorted to ground. This part switches power to the starter when you turn the key or press start.

Can I drive with code P0616?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0616?

Common possibilities to test include: control wire shorted to ground; faulty starter relay; corroded connector; computer driver circuit fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.