Home › Code lookup › P061C
Powertrain code · Computer

P061C Internal Control Module Engine RPM Performance

How urgent? Get it checked in the next few days

What it means

The engine computer's internal check of engine speed (RPM) failed.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Test the battery and charging system
  2. Check the computer power and ground circuits and connectors
  3. Check for manufacturer software updates or service bulletins

Signs you may notice

  • Check engine light on
  • Reduced power or limp mode
  • Possible stalling

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonInternal computer fault
  • CommonErratic or faulty crankshaft position sensor signal
  • PossibleLow voltage or poor power and ground connections
  • PossibleComputer software that needs an update

Typical repair once the cause is confirmed

Fix any power or ground problem first; otherwise the computer may need reprogramming or replacement (a new one usually must be programmed to the car).

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P061C mean?

The engine computer's internal check of engine speed (RPM) failed.

Can I drive with code P061C?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P061C?

Common possibilities to test include: internal computer fault; erratic or faulty crankshaft position sensor signal; low voltage or poor power and ground connections; computer software that needs an update. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.