Home › Code lookup › P062B
Powertrain code · Computer

P062B Internal Control Module Fuel Injector Control Performance

How urgent? Get it checked in the next few days

What it means

The part of the engine computer that fires the fuel injectors failed a self-check.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Test the battery and charging system
  2. Check the computer power and ground circuits and connectors
  3. Check for manufacturer software updates or service bulletins

Signs you may notice

  • Check engine light on
  • Misfire, rough running or stalling
  • Possible no start

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonInternal computer fault
  • CommonShorted fuel injector or injector wiring overloading the driver
  • PossibleLow voltage or poor power and ground connections
  • PossibleComputer software that needs an update

Typical repair once the cause is confirmed

Fix any power or ground problem first; otherwise the computer may need reprogramming or replacement (a new one usually must be programmed to the car).

Known on these vehicles

Walk through it step by step: Engine sputters or misfires →

Common questions

What does P062B mean?

The part of the engine computer that fires the fuel injectors failed a self-check.

Can I drive with code P062B?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P062B?

Common possibilities to test include: internal computer fault; shorted fuel injector or injector wiring overloading the driver; low voltage or poor power and ground connections; computer software that needs an update. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.