Home › Code lookup › P0634
Powertrain code · Computer

P0634 PCM/ECM/TCM Internal Temperature Too High

How urgent? Get it checked in the next few days

What it means

A control computer is reporting that it is running too hot inside.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Test the battery and charging system
  2. Check the computer power and ground circuits and connectors
  3. Check for manufacturer software updates or service bulletins

Signs you may notice

  • Check engine light on
  • Reduced power, limp mode or stalling
  • Possible harsh shifting

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonInternal computer fault
  • CommonShorted sensor, solenoid or actuator overloading the computer
  • PossibleComputer mounted near a heat source or blocked cooling
  • PossibleLow or overheated transmission fluid (computers mounted in the transmission)

Typical repair once the cause is confirmed

Fix any shorted part or heat problem first; otherwise replace and program the computer.

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P0634 mean?

A control computer is reporting that it is running too hot inside.

Can I drive with code P0634?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0634?

Common possibilities to test include: internal computer fault; shorted sensor, solenoid or actuator overloading the computer; computer mounted near a heat source or blocked cooling; low or overheated transmission fluid (computers mounted in the transmission). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.