Home › Code lookup › P0635
Powertrain code · Steering and suspension

P0635 Power Steering Control Circuit

How urgent? Get it checked in the next few days

What it means

The computer found a problem, such as a broken connection, in the circuit it uses to control the power steering control circuit. This part controls the steering assist motor or valve on electric or variable-assist power steering.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the power steering control circuit wiring and connector for damage or corrosion
  2. Check related fuses and relays
  3. Test the power steering control circuit with a meter or scan tool and compare with spec

Signs you may notice

  • Steering heavier than normal
  • Power steering warning light on
  • Check engine light on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty power steering control circuit
  • CommonBroken wire or loose or corroded connector
  • PossibleBlown fuse or failed relay
  • PossibleComputer driver circuit fault (rare)

Typical repair once the cause is confirmed

Usually a wiring or connector repair, or a new power steering control circuit if it tests bad.

Walk through it step by step: Steering hard to turn →

Common questions

What does P0635 mean?

The computer found a problem, such as a broken connection, in the circuit it uses to control the power steering control circuit. This part controls the steering assist motor or valve on electric or variable-assist power steering.

Can I drive with code P0635?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0635?

Common possibilities to test include: faulty power steering control circuit; broken wire or loose or corroded connector; blown fuse or failed relay; computer driver circuit fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.