Home › Code lookup › P0638
Powertrain code · Speed and idle control

P0638 Throttle Actuator Control Range/Performance Bank 1

How urgent? Get it checked in the next few days

What it means

The electronic throttle on bank 1 isn't opening or closing to the position the computer commands.

Can I keep driving?

Be careful: the car may suddenly drop into limp mode with very little power, which is risky when merging or crossing traffic. If it's in limp mode or stalling, drive slowly to a safe place or have it towed. Otherwise get it checked soon and avoid highways.

What to test before replacing parts

Inspect and clean the throttle body, check battery voltage, wiring and connector, and compare actual and commanded throttle position on a scan tool before replacing the throttle body.

  1. Inspect and clean the throttle body
  2. Check the throttle body connector and wiring
  3. Compare commanded and actual throttle position on a scan tool
  4. Perform a throttle relearn after cleaning

Signs you may notice

  • Reduced power or limp mode warning
  • Rough, high or low idle, or stalling
  • Poor or delayed acceleration
  • Check engine light on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonDirty or sticking throttle body
  • CommonFaulty electronic throttle body motor or position sensor
  • PossibleDamaged wiring or corroded connector at the throttle body
  • PossibleLow system voltage
  • PossibleEngine computer fault (rare)

Typical repair once the cause is confirmed

Usually a throttle body cleaning and relearn, or a new electronic throttle body.

Repair costInsufficient verified pricing for this vehicle and repair
Replace electronic throttle body. Prepare an itemized shop request.

Known on these vehicles

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P0638 mean?

The electronic throttle on bank 1 isn't opening or closing to the position the computer commands.

Can I drive with code P0638?

Be careful: the car may suddenly drop into limp mode with very little power, which is risky when merging or crossing traffic. If it's in limp mode or stalling, drive slowly to a safe place or have it towed. Otherwise get it checked soon and avoid highways.

What causes P0638?

Common possibilities to test include: dirty or sticking throttle body; faulty electronic throttle body motor or position sensor; damaged wiring or corroded connector at the throttle body; low system voltage. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.