Home › Code lookup › P063D
Powertrain code · Electrical

P063D Generator Voltage Sense Circuit High

How urgent? Get it checked in the next few days

What it means

The wire the computer uses to sense the alternator output voltage is reading too high, so it may not control charging correctly.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Measure charging voltage at the battery with the engine running
  2. Inspect the alternator connector and sense wiring

Signs you may notice

  • Battery warning light on
  • Battery undercharging or overcharging
  • Check engine light on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSense wire shorted to voltage
  • CommonFaulty alternator or voltage regulator
  • PossibleCorroded connector or poor ground

Typical repair once the cause is confirmed

Usually a wiring or connector repair, or a new alternator.

Walk through it step by step: Battery light on →

Common questions

What does P063D mean?

The wire the computer uses to sense the alternator output voltage is reading too high, so it may not control charging correctly.

Can I drive with code P063D?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P063D?

Common possibilities to test include: sense wire shorted to voltage; faulty alternator or voltage regulator; corroded connector or poor ground. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.