P0660 Intake Manifold Tuning Valve Control Circuit/Open Bank 1
What it means
The computer found a problem in the circuit for the valve inside the intake manifold that changes how air flows to the engine at different speeds.
Can I keep driving?
Usually safe to keep driving and book a repair; you may notice slightly less power. If you hear a rattle from the intake, get it checked sooner, since broken valve pieces can be drawn into the engine.
What to test before replacing parts
Command the valve with a scan tool and watch it move, check the fuse, wiring and connector, and inspect for carbon or broken parts before replacing the actuator.
- Inspect the actuator connector and wiring
- Check the fuse that powers the actuator
- Command the valve with a scan tool and watch whether it moves
Signs you may notice
- Check engine light on
- Slight loss of power or hesitation at some engine speeds
- Possible rough idle
- Rattle from the intake if the valve has broken
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty intake manifold tuning valve actuator or solenoid
- CommonDamaged wiring or corroded connector at the actuator
- PossibleValve sticking from carbon buildup
- PossibleBlown fuse
- PossibleEngine computer fault (rare)
Typical repair once the cause is confirmed
Usually a new tuning valve actuator or a wiring repair; some engines need a new intake manifold if the valve is built in.
Common questions
What does P0660 mean?
The computer found a problem in the circuit for the valve inside the intake manifold that changes how air flows to the engine at different speeds.
Can I drive with code P0660?
Usually safe to keep driving and book a repair; you may notice slightly less power. If you hear a rattle from the intake, get it checked sooner, since broken valve pieces can be drawn into the engine.
What causes P0660?
Common possibilities to test include: faulty intake manifold tuning valve actuator or solenoid; damaged wiring or corroded connector at the actuator; valve sticking from carbon buildup; blown fuse. A shop should confirm the cause before replacing parts.