Home › Code lookup › P0663
Powertrain code · Fuel and air

P0663 Intake Manifold Tuning Valve Control Circuit/Open Bank 2

How urgent? Book a check when convenient

What it means

The computer found a problem, such as a broken connection, in the circuit it uses to control the intake manifold tuning valve. This part changes how air flows inside the intake manifold to improve power at different engine speeds.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the intake manifold tuning valve wiring and connector for damage or corrosion
  2. Check related fuses and relays
  3. Test the intake manifold tuning valve with a meter or scan tool and compare with spec

Signs you may notice

  • Check engine light on
  • Slight loss of power or hesitation at some engine speeds

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty intake manifold tuning valve
  • CommonBroken wire or loose or corroded connector
  • PossibleBlown fuse or failed relay
  • PossibleComputer driver circuit fault (rare)

Typical repair once the cause is confirmed

Usually a new tuning valve actuator or a wiring repair; some engines need a new intake manifold if the valve is built in.

Common questions

What does P0663 mean?

The computer found a problem, such as a broken connection, in the circuit it uses to control the intake manifold tuning valve. This part changes how air flows inside the intake manifold to improve power at different engine speeds.

Can I drive with code P0663?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0663?

Common possibilities to test include: faulty intake manifold tuning valve; broken wire or loose or corroded connector; blown fuse or failed relay; computer driver circuit fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.