P0685 ECM/PCM Power Relay Control Circuit/Open
What it means
The computer found a problem, such as a broken connection, in the circuit it uses to control the engine computer power relay. This part supplies main power to the engine computer and keeps it on briefly after shutdown.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the engine computer power relay wiring and connector for damage or corrosion
- Check related fuses and relays
- Test the engine computer power relay with a meter or scan tool and compare with spec
Signs you may notice
- Engine may not start or may stall
- Battery may drain overnight if the relay sticks on
- Check engine light on
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty engine computer power relay
- CommonBroken wire or loose or corroded connector
- PossibleBlown fuse or failed relay
- PossibleComputer driver circuit fault (rare)
Typical repair once the cause is confirmed
Usually a wiring or connector repair, or a new engine computer power relay if it tests bad.
Common questions
What does P0685 mean?
The computer found a problem, such as a broken connection, in the circuit it uses to control the engine computer power relay. This part supplies main power to the engine computer and keeps it on briefly after shutdown.
Can I drive with code P0685?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0685?
Common possibilities to test include: faulty engine computer power relay; broken wire or loose or corroded connector; blown fuse or failed relay; computer driver circuit fault (rare). A shop should confirm the cause before replacing parts.