Home › Code lookup › P0690
Powertrain code · Electrical

P0690 ECM/PCM Power Relay Sense Circuit High

How urgent? Get it checked in the next few days

What it means

The computer checks the voltage coming out of its own power relay, and that sense signal is too high.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the power relay and the fuses it feeds
  2. Test the battery and clean the terminals
  3. Inspect wiring at the fuse box and computer

Signs you may notice

  • Engine may not start or may stall
  • Battery may drain overnight if the relay sticks on
  • Check engine light on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty engine computer power relay
  • CommonBlown fuse in the relay output circuit
  • PossibleDamaged wiring or corroded connector
  • PossibleWeak battery or poor battery connections

Typical repair once the cause is confirmed

Usually a new power relay or fuse, or a wiring repair.

Walk through it step by step: Car won't start →

Common questions

What does P0690 mean?

The computer checks the voltage coming out of its own power relay, and that sense signal is too high.

Can I drive with code P0690?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0690?

Common possibilities to test include: faulty engine computer power relay; blown fuse in the relay output circuit; damaged wiring or corroded connector; weak battery or poor battery connections. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.