P0698 Sensor Reference Voltage "C" Circuit Low
What it means
The computer feeds a steady 5-volt supply to a group of sensors, and supply "C" is being pulled too low, usually by a short to ground. Several sensors can stop reading correctly at once.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Note which other sensor codes set at the same time
- Unplug sensors on that circuit one at a time and watch whether the 5-volt supply comes back
- Inspect the harness for rubbing, melting or water damage
Signs you may notice
- Check engine light on
- Reduced power or limp mode
- Several sensor codes at the same time
- Possible stalling or no start
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonShorted sensor on the shared 5-volt circuit (such as a throttle, pedal or pressure sensor)
- CommonChafed or damaged wiring shorted to ground
- PossibleCorroded or water-damaged connector
- PossibleEngine computer fault
Typical repair once the cause is confirmed
Usually finding and replacing the sensor that is shorting the supply, or repairing damaged wiring.
Common questions
What does P0698 mean?
The computer feeds a steady 5-volt supply to a group of sensors, and supply "C" is being pulled too low, usually by a short to ground. Several sensors can stop reading correctly at once.
Can I drive with code P0698?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0698?
Common possibilities to test include: shorted sensor on the shared 5-volt circuit (such as a throttle, pedal or pressure sensor); chafed or damaged wiring shorted to ground; corroded or water-damaged connector; engine computer fault. A shop should confirm the cause before replacing parts.