Home › Code lookup › P0699
Powertrain code · Electrical

P0699 Sensor Reference Voltage "C" Circuit High

How urgent? Get it checked in the next few days

What it means

The computer feeds a steady 5-volt supply to a group of sensors, and supply "C" is too high, usually from a short to another voltage source. Several sensors can stop reading correctly at once.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Note which other sensor codes set at the same time
  2. Unplug sensors on that circuit one at a time and watch whether the 5-volt supply comes back
  3. Inspect the harness for rubbing, melting or water damage

Signs you may notice

  • Check engine light on
  • Reduced power or limp mode
  • Several sensor codes at the same time
  • Possible stalling or no start

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • Common5-volt supply wire shorted to a higher voltage
  • CommonFaulty sensor on the shared circuit
  • PossibleCorroded connector letting moisture bridge pins
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually finding and replacing the sensor that is shorting the supply, or repairing damaged wiring.

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P0699 mean?

The computer feeds a steady 5-volt supply to a group of sensors, and supply "C" is too high, usually from a short to another voltage source. Several sensors can stop reading correctly at once.

Can I drive with code P0699?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0699?

Common possibilities to test include: 5-volt supply wire shorted to a higher voltage; faulty sensor on the shared circuit; corroded connector letting moisture bridge pins; engine computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.