Home › Code lookup › P06A3
Powertrain code · Electrical

P06A3 Sensor Reference Voltage "D" Circuit/Open

How urgent? Get it checked in the next few days

What it means

The computer feeds a steady 5-volt supply to a group of sensors, and supply "D" has dropped out or is not reaching the sensors. Several sensors can stop reading correctly at once.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Note which other sensor codes set at the same time
  2. Unplug sensors on that circuit one at a time and watch whether the 5-volt supply comes back
  3. Inspect the harness for rubbing, melting or water damage

Signs you may notice

  • Check engine light on
  • Reduced power or limp mode
  • Several sensor codes at the same time
  • Possible stalling or no start

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonShorted sensor on the shared 5-volt circuit (such as a throttle, pedal or pressure sensor)
  • CommonChafed or damaged wiring shorted to ground
  • PossibleCorroded or water-damaged connector
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually finding and replacing the sensor that is upsetting the supply, or repairing damaged wiring.

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P06A3 mean?

The computer feeds a steady 5-volt supply to a group of sensors, and supply "D" has dropped out or is not reaching the sensors. Several sensors can stop reading correctly at once.

Can I drive with code P06A3?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P06A3?

Common possibilities to test include: shorted sensor on the shared 5-volt circuit (such as a throttle, pedal or pressure sensor); chafed or damaged wiring shorted to ground; corroded or water-damaged connector; engine computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.