P06B1 Sensor Power Supply "A" Circuit Low
What it means
The computer powers a group of sensors through supply "A", and that supply is too low, usually from a short to ground.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Note which sensor codes set at the same time
- Check fuses for the sensor supply
- Unplug sensors on the circuit one at a time to find a short
Signs you may notice
- Check engine light on
- Reduced power or limp mode
- Several sensor codes at the same time
- Possible stalling or no start
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonShorted sensor on the supply circuit
- CommonChafed wiring or blown fuse
- PossibleCorroded or water-damaged connector
- PossibleComputer fault (rare)
Typical repair once the cause is confirmed
Usually replacing a shorted sensor or repairing the wiring or fuse.
Common questions
What does P06B1 mean?
The computer powers a group of sensors through supply "A", and that supply is too low, usually from a short to ground.
Can I drive with code P06B1?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P06B1?
Common possibilities to test include: shorted sensor on the supply circuit; chafed wiring or blown fuse; corroded or water-damaged connector; computer fault (rare). A shop should confirm the cause before replacing parts.