Home › Code lookup › P06B2
Powertrain code · Electrical

P06B2 Sensor Power Supply "A" Circuit High

How urgent? Get it checked in the next few days

What it means

The computer powers a group of sensors through supply "A", and that supply is too high, usually from a short to another voltage.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Note which sensor codes set at the same time
  2. Check fuses for the sensor supply
  3. Unplug sensors on the circuit one at a time to find a short

Signs you may notice

  • Check engine light on
  • Reduced power or limp mode
  • Several sensor codes at the same time
  • Possible stalling or no start

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSupply wire shorted to another voltage source
  • CommonFaulty sensor on the circuit
  • PossibleCorroded connector
  • PossibleComputer fault (rare)

Typical repair once the cause is confirmed

Usually replacing a shorted sensor or repairing the wiring or fuse.

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P06B2 mean?

The computer powers a group of sensors through supply "A", and that supply is too high, usually from a short to another voltage.

Can I drive with code P06B2?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P06B2?

Common possibilities to test include: supply wire shorted to another voltage source; faulty sensor on the circuit; corroded connector; computer fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.