Home › Code lookup › P06B7
Powertrain code · Computer

P06B7 Internal Control Module Knock Sensor Processor 2 Performance

How urgent? Book a check when convenient

What it means

The part of the engine computer that listens to the knock sensors (processor 2) failed a self-check.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Test the battery and charging system
  2. Check the computer power and ground circuits and connectors
  3. Check for manufacturer software updates or service bulletins

Signs you may notice

  • Check engine light on
  • Possible reduced power or poor fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonInternal computer fault
  • CommonShorted knock sensor or knock sensor wiring
  • PossibleLow voltage or poor power and ground connections
  • PossibleComputer software that needs an update

Typical repair once the cause is confirmed

Fix any power or ground problem first; otherwise the computer may need reprogramming or replacement (a new one usually must be programmed to the car).

Common questions

What does P06B7 mean?

The part of the engine computer that listens to the knock sensors (processor 2) failed a self-check.

Can I drive with code P06B7?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P06B7?

Common possibilities to test include: internal computer fault; shorted knock sensor or knock sensor wiring; low voltage or poor power and ground connections; computer software that needs an update. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.