Home › Code lookup › P06D1
Powertrain code · Ignition

P06D1 Internal Control Module Ignition Coil Control Performance

How urgent? Otherwise: Get it checked in the next few days

What it means

The part of the engine computer that fires the ignition coils failed a self-check.

Can I keep driving?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away.

Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check for misfire or coil circuit codes
  2. Inspect ignition coil wiring and connectors
  3. Test the battery and computer grounds

Signs you may notice

  • Check engine light on
  • Misfire or rough running
  • Possible stalling or no start

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonShorted ignition coil or coil wiring overloading the driver
  • CommonInternal computer fault
  • PossibleLow voltage or poor power and ground connections
  • PossibleComputer software that needs an update

Typical repair once the cause is confirmed

Replace any shorted coil or repair wiring first; otherwise the computer may need replacement.

Walk through it step by step: Engine sputters or misfires →

Common questions

What does P06D1 mean?

The part of the engine computer that fires the ignition coils failed a self-check.

Can I drive with code P06D1?

If the check engine light is flashing or the engine is shaking hard, pull over when it's safe and turn the engine off. Don't keep driving; a heavy misfire can overheat and ruin the catalytic converter and leave you without power in traffic. Have it towed or checked right away. Otherwise: If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P06D1?

Common possibilities to test include: shorted ignition coil or coil wiring overloading the driver; internal computer fault; low voltage or poor power and ground connections; computer software that needs an update. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.