U0402 Invalid Data Received From TCM
What it means
Another module received a message from the transmission control module that does not make sense, such as a value that is out of range or does not add up. It controls the automatic transmission.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the transmission control module for its own stored codes and fix those first
- Test the battery and grounds
- Check for software updates or service bulletins
Signs you may notice
- Check engine or transmission light on
- Transmission may stay in one gear (limp mode)
- Harsh shifts or no shifts
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty transmission sensor feeding the TCM
- CommonThe transmission control module needs a software update
- CommonLow battery voltage or poor ground causing bad messages
- PossibleNetwork wiring problem or interference
- PossibleFailed transmission control module
Typical repair once the cause is confirmed
Fix any fault in the transmission control module or its sensors, then update the software if needed.
Common questions
What does U0402 mean?
Another module received a message from the transmission control module that does not make sense, such as a value that is out of range or does not add up. It controls the automatic transmission.
Can I drive with code U0402?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes U0402?
Common possibilities to test include: faulty transmission sensor feeding the tcm; the transmission control module needs a software update; low battery voltage or poor ground causing bad messages; network wiring problem or interference. A shop should confirm the cause before replacing parts.