U0403 Invalid Data Received From Transfer Case Control Module
What it means
Another module received a message from the transfer case control module that does not make sense, such as a value that is out of range or does not add up. It controls power to the front or rear wheels.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the transfer case control module for its own stored codes and fix those first
- Test the battery and grounds
- Check for software updates or service bulletins
Signs you may notice
- 4WD or AWD warning light on
- 4WD or AWD may not engage
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty sensor or input feeding the transfer case control module
- CommonThe transfer case control module needs a software update
- CommonLow battery voltage or poor ground causing bad messages
- PossibleNetwork wiring problem or interference
- PossibleFailed transfer case control module
Typical repair once the cause is confirmed
Fix any fault in the transfer case control module or its sensors, then update the software if needed.
Common questions
What does U0403 mean?
Another module received a message from the transfer case control module that does not make sense, such as a value that is out of range or does not add up. It controls power to the front or rear wheels.
Can I drive with code U0403?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes U0403?
Common possibilities to test include: faulty sensor or input feeding the transfer case control module; the transfer case control module needs a software update; low battery voltage or poor ground causing bad messages; network wiring problem or interference. A shop should confirm the cause before replacing parts.