Home › Code lookup › U0408
Network code · Network

U0408 Invalid Data Received From Throttle Actuator Control Module

How urgent? Get it checked in the next few days

What it means

Another module received a message from the throttle actuator control module that does not make sense, such as a value that is out of range or does not add up. It helps run part of the engine or drivetrain.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the throttle actuator control module for its own stored codes and fix those first
  2. Test the battery and grounds
  3. Check for software updates or service bulletins

Signs you may notice

  • Check engine light on
  • Engine may run poorly, lose power or not start

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty sensor or input feeding the throttle actuator control module
  • CommonThe throttle actuator control module needs a software update
  • CommonLow battery voltage or poor ground causing bad messages
  • PossibleNetwork wiring problem or interference
  • PossibleFailed throttle actuator control module

Typical repair once the cause is confirmed

Fix any fault in the throttle actuator control module or its sensors, then update the software if needed.

Walk through it step by step: Check engine light on →

Common questions

What does U0408 mean?

Another module received a message from the throttle actuator control module that does not make sense, such as a value that is out of range or does not add up. It helps run part of the engine or drivetrain.

Can I drive with code U0408?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes U0408?

Common possibilities to test include: faulty sensor or input feeding the throttle actuator control module; the throttle actuator control module needs a software update; low battery voltage or poor ground causing bad messages; network wiring problem or interference. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.