U0406 Invalid Data Received From Fuel Injector Control Module
What it means
Another module received a message from the fuel injector control module that does not make sense, such as a value that is out of range or does not add up. It helps run part of the engine or drivetrain.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the fuel injector control module for its own stored codes and fix those first
- Test the battery and grounds
- Check for software updates or service bulletins
Signs you may notice
- Check engine light on
- Engine may run poorly, lose power or not start
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty sensor or input feeding the fuel injector control module
- CommonThe fuel injector control module needs a software update
- CommonLow battery voltage or poor ground causing bad messages
- PossibleNetwork wiring problem or interference
- PossibleFailed fuel injector control module
Typical repair once the cause is confirmed
Fix any fault in the fuel injector control module or its sensors, then update the software if needed.
Common questions
What does U0406 mean?
Another module received a message from the fuel injector control module that does not make sense, such as a value that is out of range or does not add up. It helps run part of the engine or drivetrain.
Can I drive with code U0406?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes U0406?
Common possibilities to test include: faulty sensor or input feeding the fuel injector control module; the fuel injector control module needs a software update; low battery voltage or poor ground causing bad messages; network wiring problem or interference. A shop should confirm the cause before replacing parts.