Home › Code lookup › P0010
Powertrain code · Engine

P0010 "A" Camshaft Position Actuator Circuit (Bank 1)

How urgent? Get it checked in the next few days

What it means

The engine uses an electric oil control valve to adjust the "A" (usually intake) camshaft timing on bank 1. The computer found a problem in the wiring or the valve itself, such as an open or shorted circuit.

Can I keep driving?

If the car idles and drives normally, you can usually drive gently to a shop in the next few days. If it stalls, idles very rough or loses power, limit driving, since stalling in traffic is dangerous. Check the oil level too; low oil makes cam timing problems worse.

What to test before replacing parts

Inspect the solenoid connector for oil or corrosion, measure solenoid resistance, check the circuit back to the computer, and command the valve with a scan tool before replacing it.

  1. Inspect the solenoid connector for oil, corrosion or a loose fit
  2. Measure the solenoid resistance and compare to spec
  3. Command the solenoid on with a scan tool and watch for a response

Signs you may notice

  • Check engine light on
  • Rough idle or stalling
  • Reduced power and fuel economy
  • Engine may run fine but with a light on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed camshaft oil control valve (VVT solenoid)
  • CommonDamaged wiring or loose connector at the solenoid
  • PossibleOil leaking into the solenoid connector
  • PossibleEngine computer driver fault

Typical repair once the cause is confirmed

Usually a new camshaft oil control valve, or a wiring or connector repair.

Repair costInsufficient verified pricing for this vehicle and repair
Replace camshaft oil control valve (VVT solenoid). Prepare an itemized shop request.

Known on these vehicles

Walk through it step by step: Check engine light on →

Common questions

What does P0010 mean?

The engine uses an electric oil control valve to adjust the "A" (usually intake) camshaft timing on bank 1. The computer found a problem in the wiring or the valve itself, such as an open or shorted circuit.

Can I drive with code P0010?

If the car idles and drives normally, you can usually drive gently to a shop in the next few days. If it stalls, idles very rough or loses power, limit driving, since stalling in traffic is dangerous. Check the oil level too; low oil makes cam timing problems worse.

What causes P0010?

Common possibilities to test include: failed camshaft oil control valve (vvt solenoid); damaged wiring or loose connector at the solenoid; oil leaking into the solenoid connector; engine computer driver fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.