Home › Code lookup › P0012
Powertrain code · Engine

P0012 "A" Camshaft Position - Timing Over-Retarded (Bank 1)

How urgent? Get it checked in the next few days

What it means

The "A" (usually intake) camshaft on bank 1 is further behind the position the computer asked for. The variable valve timing system is not controlling it correctly.

Can I keep driving?

Check the oil level first; low or dirty oil is a common cause. If the engine runs smoothly, drive gently to a shop soon. If it stalls, runs very rough, loses power, rattles loudly or the oil light comes on, stop driving; low oil pressure or jumped timing can ruin the engine.

What to test before replacing parts

Check oil level, grade and condition, inspect the oil control valve screen, and compare commanded and actual cam position on a scan tool before replacing a phaser or timing chain.

  1. Check the oil level and change it if dirty or overdue, using the correct grade
  2. Remove and inspect the oil control valve for sludge or a stuck spool
  3. Check cam timing values with a scan tool before replacing the phaser or chain

Signs you may notice

  • Check engine light on
  • Rough idle, especially when warm
  • Hesitation or loss of power
  • Possible stalling or rattle at startup

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLow, dirty or wrong-grade engine oil
  • CommonSticking or failed camshaft oil control valve
  • CommonWorn camshaft phaser or phaser stuck retarded
  • PossibleStretched timing chain or jumped timing
  • PossibleClogged oil screen at the oil control valve

Typical repair once the cause is confirmed

Start with an oil change. If it comes back, the oil control valve is the most common fix, then the phaser or timing chain.

Repair costInsufficient verified pricing for this vehicle and repair
Replace camshaft oil control valve (VVT solenoid). Prepare an itemized shop request.

Where it shows up

  • Common on the Ford 5.4L 3-valve V8 (F-150, Expedition) when the cam phasers wear
Walk through it step by step: Check engine light on →

Common questions

What does P0012 mean?

The "A" (usually intake) camshaft on bank 1 is further behind the position the computer asked for. The variable valve timing system is not controlling it correctly.

Can I drive with code P0012?

Check the oil level first; low or dirty oil is a common cause. If the engine runs smoothly, drive gently to a shop soon. If it stalls, runs very rough, loses power, rattles loudly or the oil light comes on, stop driving; low oil pressure or jumped timing can ruin the engine.

What causes P0012?

Common possibilities to test include: low, dirty or wrong-grade engine oil; sticking or failed camshaft oil control valve; worn camshaft phaser or phaser stuck retarded; stretched timing chain or jumped timing. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.