P0013 "B" Camshaft Position Actuator Circuit (Bank 1)
What it means
The engine uses an electric oil control valve to adjust the "B" (usually exhaust) camshaft timing on bank 1. The computer found a problem in the wiring or the valve itself, such as an open or shorted circuit.
Can I keep driving?
If the car idles and drives normally, you can usually drive gently to a shop in the next few days. If it stalls, idles very rough or loses power, limit driving, since stalling in traffic is dangerous. Check the oil level too; low oil makes cam timing problems worse.
What to test before replacing parts
Inspect the solenoid connector for oil or corrosion, measure solenoid resistance, check the circuit back to the computer, and command the valve with a scan tool before replacing it.
- Inspect the solenoid connector for oil, corrosion or a loose fit
- Measure the solenoid resistance and compare to spec
- Command the solenoid on with a scan tool and watch for a response
Signs you may notice
- Check engine light on
- Rough idle or stalling
- Reduced power and fuel economy
- Engine may run fine but with a light on
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed camshaft oil control valve (VVT solenoid)
- CommonDamaged wiring or loose connector at the solenoid
- PossibleOil leaking into the solenoid connector
- PossibleEngine computer driver fault
Typical repair once the cause is confirmed
Usually a new camshaft oil control valve, or a wiring or connector repair.
Common questions
What does P0013 mean?
The engine uses an electric oil control valve to adjust the "B" (usually exhaust) camshaft timing on bank 1. The computer found a problem in the wiring or the valve itself, such as an open or shorted circuit.
Can I drive with code P0013?
If the car idles and drives normally, you can usually drive gently to a shop in the next few days. If it stalls, idles very rough or loses power, limit driving, since stalling in traffic is dangerous. Check the oil level too; low oil makes cam timing problems worse.
What causes P0013?
Common possibilities to test include: failed camshaft oil control valve (vvt solenoid); damaged wiring or loose connector at the solenoid; oil leaking into the solenoid connector; engine computer driver fault. A shop should confirm the cause before replacing parts.