Home › Code lookup › P001A
Powertrain code · Engine

P001A "A" Camshaft Profile Control Circuit/Open (Bank 1)

How urgent? Book a check when convenient

What it means

Some engines can switch between two camshaft lobe shapes, one for economy and one for power. The computer found an open or broken connection in the control circuit for this switching on bank 1.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the oil level and condition
  2. Inspect the solenoid connector and wiring
  3. Test the solenoid resistance and command it with a scan tool

Signs you may notice

  • Check engine light on
  • Less power at higher engine speeds
  • Engine may stay in one cam mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonDamaged wiring or loose connector to the cam profile solenoid
  • CommonFailed cam profile switching solenoid
  • PossibleLow or dirty engine oil affecting the switching mechanism
  • PossibleEngine computer driver fault

Typical repair once the cause is confirmed

Usually a wiring repair or a new cam profile switching solenoid.

Walk through it step by step: Check engine light on →

Common questions

What does P001A mean?

Some engines can switch between two camshaft lobe shapes, one for economy and one for power. The computer found an open or broken connection in the control circuit for this switching on bank 1.

Can I drive with code P001A?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P001A?

Common possibilities to test include: damaged wiring or loose connector to the cam profile solenoid; failed cam profile switching solenoid; low or dirty engine oil affecting the switching mechanism; engine computer driver fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.